Impact Sensor: Service and Repair

REMOVAL
1. Record USER 1 and USER 2 pre-set radio frequencies for reprogramming following completion of service procedures.
2. Disconnect battery ground cable. Wait one minute for backup power supply to deplete its stored energy.






3. Remove radiator upper sight shield.
4. Remove three screws retaining radiator support and Grille Opening Panel (GOP) bracket and remove sensor and bracket.
5. Disconnect sensor from wire harness.
6. Remove two retaining screws and sensor from bracket.






INSTALLATION
1. Install RH/LH front primary crash sensor to radiator support and grille opening panel bracket with two retaining screws tightened to 10.2-13.8 Nm (90-122 lb in).
2. Connect sensor to wire harness.
3. Position RH/LH front primary crash sensor and bracket in vehicle and secure with three retaining screws. Tighten screws to 10.2-13.8 Nm (90-122 lb-in).
4. Install radiator upper sight shield.
5. Connect battery ground cable.
6. Prove out air bag system.
7. Reprogram radio frequencies and set clock.