Oil Pump: Service and Repair

Fig. 18 Oil Pump Assembly:

REMOVAL
1. Remove engine front cover (6019).
2. Remove oil pan (6675) and oil pump screen cover and tube (6622).
3. Remove primary timing chains.
4. Remove crankshaft sprockets (6306).
5. Remove four bolts retaining oil pump (6600) to cylinder block (6010). Remove oil pump.

INSTALLATION
1. Rotate inner rotor of oil pump to align with flats on crankshaft (6303) and install oil pump flush with cylinder block.





2. Install four retaining bolts and tighten to 8-12 Nm (71-106 inch lbs.).
3. Replace oil bypass filter (6714).
4. Install timing chains.
5. Install oil pump screen cover and tube and oil pan.
6. Install engine front cover.
7. Fill crankcase to specified level with clean engine oil meeting Ford specification WSS-M2C153-F.
8. Start engine and check for leaks.