Transmission Position Sensor/Switch: Adjustments

NOTE: Use Digital Transmission Range TR Sensor Alignment Tool to align the digital TR sensors.

1. Raise and support vehicle.

WARNING: The electrical power to the air suspension system must be shut off prior to hoisting, jacking or towing an air suspension vehicle. This can be accomplished by turning off the air suspension switch located in the RH kick panel area. Failure to do so may result in unexpected inflation or deflation of the air springs which may result in shifting of the vehicle during these operations.





2. Disconnect the manual lever shift control cable.





3. Loosen the digital transmission range TR sensor bolts.





4. Use TR sensor alignment tool, to align the digital TR sensor slots.

NOTE: Manual shift lever must be in the neutral position.





5. Tighten the digital TR sensor bolts.





6. With the manual lever in overdrive connect the shift lever control cable.
7. Install the digital TR sensor electrical connector.
8. Lower the vehicle.

NOTE: If equipped with air suspension, reactivate the system by turning on the air suspension switch.