Procedure 2 - Remote Deployment of Air Bags

WARNING: Remote deployment is to be performed outdoors with all personnel at least 6 m (20 feet) away to ensure personal safety and due to the loud report which occurs when driver side air bag module and passenger side air bag module are deployed.

NOTE: Refer to Service Precautions for Safety Information and Warnings.

1. Remove the Driver Side Air Bag Module or the Passenger Side Air Bag Module from the vehicle.

WARNING: Place the air bag module on the bench with the trim cover facing up to avoid accidental deployment and possible personal injury.






2. Cut and strip the module connector wires.






3. Attach two wires to the module connector wires.

4. Place the air bag module with the trim cover facing upward on a flat surface in a remote area.

5. Move away from the air bag module.

6. Deploy the air bag module.
- Touch the ends of the extension wires to terminals of a 12-volt battery.

7. Scrap the air bags in accordance with the scrap metal procedures.

NOTE: Allow 10 minutes for the air bags to cool before handling them.