General Specifications

Cylinder Head Gasket Surface
Flatness, Maximum [1] 0.10 mm (0.004 inch)
Finish [3]
Resurface, Maximum Not Permitted
Valve To Guide Clearance See: Valve

Valve Arrangements [2] (Front-to-Rear)
LH Intake S-P-S-P-S-P-S-P
LH Exhaust E-E-E-E-E-E-E-E
RH Intake P-S-P-S-P-S-P-S
RH Exhaust E-E-E-E-E-E-E-E

[1] Over the entire cylinder head gasket surface.
[2] P = Primary, S = Secondary, E = Exhaust
[3] Head Gasket Surface - WT = 10.0 minus 2.5 Microns. Head Gasket Surface Finish - RZU - 13.5 0.8 TPI 6396 MIN. Ra 3.0-3.5 J80. This ID is obtained using a hand-held profilometer.