Ranges/Modes

DESCRIPTION
The transmission range selector lever has six positions: P, R, N, D, 2 and 1.

(P) PARK

CAUTION: The vehicle parking brake should always be used when the vehicle is in Park.

In the Park position:
^ There is no power-flow through the transmission.
^ The parking pawl locks the output shaft to the case.
^ The engine may be started.
^ The ignition key may be removed.

(R) REVERSE
In the Reverse position:
^ The vehicle may be operated in a rearward direction, at a reduced gear ratio.
^ Engine braking will occur.

(N) NEUTRAL
In the Neutral position:
^ There is no power-flow through the transmission.
^ The output shaft is not held and is free to turn.
^ The engine may be started.

(OD) OVERDRIVE
Overdrive is the normal position for most forward driving. The Overdrive position provides:
^ Automatic shifts.
^ Apply and release of the torque converter clutch.
^ Maximum fuel economy during normal operation.

(2) MANUAL SECOND
This position provides:
^ Second gear start and hold.
^ The torque converter clutch may apply and release.
^ Improved traction and engine braking on slippery roads.

(1) MANUAL LOW
If this position is selected at normal road speeds, the transmission will shift into second gear, then into first when the vehicle reaches a speed below approximately 45 km/h (28 mph). This position provides:
^ First gear operation only.
^ Engine braking for descending steep grades.