Door Striker

NOTE
- This procedure applies to front and rear.
- Do not try to correct a poor door alignment with door latch striker plate adjustments.

1. Before adjusting door latch striker plate, open and close door to double-check door latch striker plate alignment.
2. Loosen door latch striker plate with correct bit from Torx(R) Drive Bit Set D79P-2100-T or equivalent. Move door latch striker plate up-or-down or from side-to-side as necessary. Tighten door latch striker plate retaining screws to 33-45 Nm (24-33 Lb-Ft).