Sliding Roof Height Adjustment

The correct position of the roof sliding outer glass panel to the roof panel is as follows:
Front Corners: Flush to 1 mm (0.039 Inch) below roof panel.
Rear Corners: Flush to 1 mm (0.039 Inch) above roof panel.

1. Cycle roof sliding outer glass panel from full-open to full-closed position.
2. Remove three roof sliding panel opening shield retaining screws along front of opening inside of vehicle and slide roof sliding panel opening shield and roof sliding panel headlining fully rearward to expose six roof sliding outer glass panel retaining screws (three on each side).
3. Loosen six roof sliding outer glass panel retaining screws. Tighten so that they are snug but not tightened to specification.
4. To adjust only the front of roof sliding outer glass panel, loosen the center and front screws. To adjust only the back of the roof sliding outer glass panel, loosen the center and rear screws.
5. To check height setting, open the roof sliding outer glass panel about 101.6 mm (4.0 Inches), then return to the closed position.
6. Tighten the glass retaining screws to 0.8-1.5 Nm (7-13 Lb-In).
7. Slide roof sliding panel opening shield forward and replace three retaining screws.
8. Close roof sliding panel headlining if desired.