Roof Sliding Panel Opening Shield

REMOVAL
1. Open roof sliding outer glass panel approximately half-way.







2. Remove three screws and roof sliding panel opening shield. Working toward the opposite side, remove front of roof sliding panel opening shield from roof sliding outer glass panel. Then close roof sliding outer glass panel.
3. Raise roof sliding outer glass panel to the full vent position.







4. On each side of the roof sliding panel opening shield, approximately half-way toward the rear, use a wide-blade screwdriver to press up on release tabs located on bottom surface (right above track screws on each side).
5. Move rear hooked ends of roof sliding panel opening shield inward up over rubber roof sliding panel headlining bumpers and remove roof sliding panel opening shield from vehicle.

INSTALLATION
1. Follow removal procedure in reverse order.