Front

REMOVAL

CAUTION: Use care when handling seat and track assembly. Dropping assembly or sitting on seat not secured in vehicle may result in damaged components.

1. Remove front seat track to floor insulators from front and rear of front seat track assembly to expose retaining nuts and bolts.
2. Center power seat and move to full-up position.
3. Disconnect battery ground cable.
4. Remove nuts and bolts retaining front seat track assembly to front floor pan.
5. Lift seat up enough to disconnect seat harness connectors. Remove the seat and track assembly from vehicle.

INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten front retaining bolts and rear outboard nut to 17-23 Nm (13-16 Lb-Ft). Tighten rear inboard nut to 68-92 Nm (51-67 Lb-Ft).
3. Check power seat for proper operation.