Power

REMOVAL

NOTE: The power seat back adjuster is a modular design and components cannot be serviced or replaced individually. The entire power seat back adjuster assembly must be replaced if any component is non-functional or damaged.

1. Disengage J-retainer and arrow retainers at outboard right rear corner and J-retainer from cushion frame side. Pull back trim cover.
2. Remove push pin retainers and remove trim cover from power seat back adjuster assembly.
3. Disconnect front seat back pad adjusting tube (if equipped) and disconnect harness connector.
4. Remove two screws retaining power front seat power adjuster assembly to front cushion frame (on outboard side) and pivot bolt on inboard side. Remove front seat back assembly.
5. Disengage J-retainers at bottom of front seat back assembly and pull up front seat back cover.
6. Remove two screws retaining power front seat adjuster assembly to front seat back frame and remove power front seat adjuster assembly.

INSTALLATION
1. Follow removal procedure in reverse order.
2. Tighten power front seat adjuster assembly retaining screws to 23-32 Nm (17-23 Lb-Ft).