Technician Safety Information
WARNING:BRAKE FLUID HAZARDS
- Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If Brake fluid contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists.
- If Taken internally, drink water and induce vomiting. Get medical attention immediately.
ASBESTOS HAZARDS
- Brakes may contain asbestos fibers. Do not breathe asbestos dust. Breathing asbestos dust may cause ASBESTOSIS and CANCER.
- Do not clean brake and clutch assemblies by dry brushing or with compressed air. Dust and dirt from brake and clutch assemblies may contain asbestos fibers that are hazardous to health when made airborne.
- Some AFTER MARKET brakes contain asbestos fibers. Avoid breathing dust.
- Dust and dirt present on wheel brake and clutch assemblies may contain asbestos fibers that are health hazards when made airborne by cleaning with compressed air or by dry brushing.
ASBESTOS SERVICING
- Wheel brake assemblies and clutch facings should be cleaned using a vacuum cleaner recommended for use with asbestos fibers such as brake/clutch/service vacuum 164-R3600 or equivalent.
- Dust and dirt from a vacuum should be disposed of in such a manner that prevent dust exposure, such as sealed bags. The bag must be labeled as per Occupational Safety And Health Administration (OSHA) instructions and the trash hauler notified as to the bag's contents.
- If a vacuum suitable for asbestos is not available, cleaning should be done wet. If dust generation is still possible, technicians should wear government-approved toxic dust-purifying respirators.
- Grinding or sanding on brake linings pads, rotors, drums or clutch facing's should be done only while using properly exhaust-ventilated equipment. OSHA requires areas where asbestos dust generation is possible to be isolated and posted with warning signs. Only technicians concerned with performing brake or clutch service should be present in the area.