Message Center Switch Module

Removal and Installation
1. Disconnect battery ground cable.
2. Set parking brake.
3. Unsnap left instrument panel moulding and right instrument panel moulding off instrument panel finish panel.
4. Pull center panel switches (if equipped) forward, disconnect electrical connectors and remove the center switches.
5. Remove seven screws retaining instrument panel finish panel and pull instrument panel finish panel out.
6. Move gearshift lever to low gear (1) position if required for easier access.
7. Remove connectors from headlamp and dimmer controls.
8. Remove instrument panel finish panel carefully so as not to scratch the instrument cluster.
9. Remove two screws on either side of message center switch module.
10. Remove message center switch module from rear of the instrument panel finish panel and replace.
11. Reverse procedure to install.