A/C Discharge Hose/Line

NOTE: Whenever a refrigerant line is replaced, it will be necessary to replace the suction accumulator/drier.

SPECIAL SERVICE TOOL(S) REQUIRED

Description Tool Number
Spring Lock Coupling Disconnect Tool (5/8 inch) T83P-19623-C







REMOVAL
1. Discharge the refrigerant from the A/C system and observing all safety precautions. Discharging and Recovery
2. Remove A/C pressure cut-off switch.
3. Loosen nut retaining A/C compressor to condenser discharge line to stud on engine front cover.
4. Disconnect and remove the A/C compressor to condenser discharge line using Spring Lock Coupling Disconnect Tool T83P-19623-C.

INSTALLATION
1. With the protective caps installed, route the new refrigerant line.
2. Remove protective caps then connect the A/C compressor to condenser discharge line into the system using new O-ring seals lubricated with clean Motorcraft YN-12b refrigerant oil or equivalent meeting Ford specification WSH-M1C231-B.
3. Tighten nut retaining A/C compressor to condenser discharge line to stud on engine front cover.
4. Install the A/C pressure cut-off switch.
5. Leak-test, evacuate and charge the refrigerant system and safety precautions. Discharging and Recovery
6. Check the A/C system for proper operation.