Front

REMOVAL
1. Raise vehicle on hoist.
2. Remove two nuts from stabilizer bar link at front stabilizer bar.
3. Remove four stabilizer bar brackets retaining nuts.
4. Remove front stabilizer bar from stabilizer bar bracket.
5. Remove lower suspension arm stabilizer bar insulator from front stabilizer bar.
6. Pry locking tab away from frame and slide stud out. Tap stud if necessary.

INSTALLATION
1. Clean area around slot.
2. Install stud into slot until spring locks.
3. Clean front stabilizer bar of dirt and other contamination. Position lower suspension arm stabilizer bar insulator on front stabilizer bar.





4. Install front stabilizer bar, lower suspension arm stabilizer bar insulator, stabilizer bar brackets and four stabilizer bar bracket retaining nuts. Tighten nuts to 26-35 Nm (19-26 ft. lbs.).
5. Position stabilizer bar links into the ends of front stabilizer bar. Tighten nuts to 26-35 Nm (20-25 ft. lbs.).