Crankshaft Main Bearing
GENERAL SPECIFICATIONSClearance to Crankshaft
Desired: 0.025-0.045 mm (0.00098-0.00177 inch)
Allowable: 0.025-0.050 mm (0.00098-0.00197 inch)
Bearing Wall Thickness (STD): 2.451 mm (0.0965 inch)
TORQUE SPECIFICATIONS
^ Tighten the bolts 1 thru 20 in the sequence shown to 8-12 Nm (71-106 in.lb).
^ Tighten the bolts 1 thru 10 in the sequence shown to 22-28 Nm (17-20 ft.lb).
^ Tighten the bolts 11 thru 20 in the sequence shown to 37-43 Nm (28-31 ft.lb).
^ Tighten the bolts 1 thru 20 in the sequence shown an additional 85°-95°.
^ Turn the ten jack screws until fully seated in the main bearing cap.
^ Install and tighten the jack screws in the sequence shown to 9-11 Nm (80-97 in.lb).
^ Install and tighten the cross-mounted bolts to 19-23 Nm (14-16 ft.lb).