Driver Door Module (DDM)

SPECIAL SERVICE TOOL(S)

REMOVAL
1. Disconnect the battery ground cable.

CAUTION: Prior to removal of module, it is necessary to upload module configuration information to scan tool This information needs to be downloaded in to the new module once installed. For additional information; refer to Module Communications Network (Information Bus).
^ Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.

2. Remove the front door trim panel.






3. Disconnect the electrical connectors from the Driver Door Module (DDM).







4. Release the retaining clips and remove the DDM.

INSTALLATION
1. To install, reverse the removal procedure.

CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the scan tool into the new module. For additional information, refer to Module Communications Network (Information Bus).

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns its adaptive strategy. The vehicle may need to be driven 10 miles (16 km) or more to relearn the strategy.

2. Program the keyless entry keypad codes and keyless entry remote transmitters. For additional information, refer to Keyless Entry.