Height Adjustment

1. Cycle the roof sliding outer glass panel from the fully/open to the fully/closed position.







2. Remove the screws and slide the roof sliding panel opening shield fully rearward.







3. Loose the screws.
^ Loosen the front and center screws to adjust the front.
^ Loosen the rear and center screws to adjust the rear.
4. Open the glass about 101.6 mm (4 inches), then close the roof sliding outer glass panel.
5. Adjust the roof.
^ Adjust the front comers flush to 1 mm (0.039 inches) below the roof.
^ Adjust the rear comers flush to 1 mm (0.039 inches) above the roof.







6. Tighten the screws.







7. Install the roof sliding panel opening shield and install the screws.