Motor Synchronization

1. Connect the roof opening panel motor connector to the roof sliding panel wiring connector.

NOTE: The glass panel should be in the CLOSED position prior to synchronizing the roof opening panel motor.

2. Hold the switch ON until roof opening panel motor stops.
3. Disconnect the roof opening panel motor connector from the roof sliding panel wiring connector.
4. Make sure that the lifter arms and guidance ramps are aligned. Connect the roof opening panel motor and install it to the roof panel.

NOTE: When installing the roof opening panel motor as an assembly to the roof opening panel, it may be necessary to turn the roof opening panel motor as an assembly slightly to engage the drive splines.