Power Steering System Filling

1. WARNING: Do not mix oil types. Any mixture or any unapproved oil could lead to seal deterioration and leaks. A leak could ultimately cause loss of fluid, which could result in loss of power steering assist.

Fill the power steering reservoir to the appropriate level.
^ Use Motorcraft MERCON Multipurpose (ATF) Transmission Fluid XT-2-QDX meeting Ford specification MERCON or equivalent.
2. Remove the ignition coil fuse number 11 (10 amp) in the instrument panel fuse box to disable the vehicle from starting.
3. Raise the front wheels off the floor.





4. CAUTION: Do not operate the starter motor for more than 10 seconds at a time. Damage to the starter motor could result.

Turn the steering wheel from stop to stop while cranking the engine.
5. Lower the vehicle.





6. CAUTION: Do not overfill the power steering fluid reservoir.

Fill the power steering fluid reservoir to the appropriate level.
^ Use Motorcraft MERCON Multipurpose (ATF) Transmission Fluid XT-2-QDX meeting Ford specification MERCON or equivalent.
7. Install the ignition coil fuse.

8. Note: If the power steering is noisy and accompanied by evidence of aerated fluid, it will. be necessary to purge the power steering system.

Clear the Diagnostic Trouble Codes (DTCs).
^ Run the vehicle and check the system for leaks.