Water Pump: Service and Repair
Removal1. Drain the engine cooling system.
2. Remove the air cleaner outlet tube.
3. Disconnect the engine vent hose.
4. Disconnect the upper radiator hose.
5. Disconnect the heater supply hose.
6. Disconnect the water pump hose.
7. Disconnect the lower radiator hose from the thermostat housing.
8. Remove the water crossover assembly.
9. Disconnect the water inlet hose from the coolant outlet pipe.
10. Disconnect and remove the water inlet hose from the pump.
11. Disconnect the heater water hose from the water pump.
12. Remove the belt idler pulley.
13. Remove the bracket.
1 Unclip the wiring harness.
2 Remove the two studbolts; and the bolt.
3 Remove the bracket.
14. Remove the bolt and the studs. Remove the water pump assembly.
Installation
1. To install, reverse the removal procedure.