Right Hand Side

Removal





1. If equipped, remove the heat shield.
2. Remove the Three-Way Catalytic Converter (TWC).





3. Remove the lower splash shield.
^ Remove the bolts.
^ Remove the pin-type retainers and the shield.





4. Note: Left side shown; right side similar.

If equipped, remove the secondary air tube from the exhaust manifold.





5. Disconnect the EGR valve to exhaust manifold tube.





6. Remove the six nuts and the exhaust manifold. Discard the gasket.

Installation





1. Note: To verify the seal, the manifold bolts must be tightened to the same specification two times.

Using a new gasket, install the exhaust manifold. Tighten the nuts in two stages:
^ Stage 1: Tighten to 20 Nm (15 ft. lbs.).
^ Stage 2: Tighten to 20 Nm (15 ft. lbs.).





2. Install the EGR valve-to-exhaust manifold tube.





3. Note: Left side shown; right side similar.

If equipped, install the secondary air tube to the exhaust manifold.





4. Install the lower splash shield.
^ Install the shield and the pin-type retainers.
^ Install the bolts.
5. Install the TWC.





6. If equipped, install the heat shield.