Yaw Rate Sensor: Service and Repair

Removal

Note: The stability assist module needs to be recalibrated whenever a component is disconnected, moved, or a new component is installed. For additional information regarding the recalibration procedure and when the recalibration procedure should be carried out, refer to Antilock Brakes / Traction Control Systems; Testing and Inspection.


1. Remove the floor console.





2. Remove the center A/C duct.





3. Disconnect the yaw rate sensor electrical connector.





4. Remove the yaw rate sensor.
1 Remove the yaw rate sensor bolts.
2 Remove the yaw rate sensor.

Installation

Note: The stability assist module needs to be recalibrated whenever a component is disconnected, moved, or a new component is installed. For additional information regarding the recalibration procedure and when the recalibration procedure should be carried out, refer to Antilock Brakes / Traction Control Systems; Testing and Inspection.


Note: The yaw rate sensor is positioned with the connector pointed to the left side of the vehicle. Be sure to mount the sensor in this orientation during the installation procedure.





1. To install, reverse the removal procedure.