Rain Sensor: Service and Repair

REMOVAL







1. Remove the rain sensor module cover.

NOTE:
^ To avoid damage to the rain sensor module cover, push up on the cover while rotating the top of the cover toward the rear of the vehicle.
^ Prior to installing the rain sensor module, the windshield glass area between the rain sensor module brackets must be cleaned.
^ When installing the rain sensor module, it is necessary to apply inward pressure on the module prior to locking the rain sensor module retaining slides in place.







2. Remove the rain sensor module.
1 Pull the latch on the connector away from the harness and disconnect the electrical connector.
2 Release the rain sensor module retaining slides.
3 Remove the rain sensor module.

NOTE: When removing the rain sensor module, it is necessary to apply inward pressure on the module prior to releasing the rain sensor module retaining slides.

INSTALLATION
1. To install, reverse the removal procedure.