Antenna Isolator Module

REMOVAL
1. Disconnect the battery ground cable. Refer to Battery.







2. Lower the LH and RH rear seat backrests.

NOTE: The rear seat back release handles are located in the luggage compartment.







3. Position the LH and RH rear seat side bolsters aside.
1. Release the upper retaining latches.
2. Position the rear seat side bolsters aside.







4. Remove the upper pass-through trim panel.
1. Remove the five pin-type retainers.
2. Release the latch covers.
3. Remove the upper pass-through trim panel.







5. Remove the high mounted stoplamp cover.







6. Position the LH and RH rear door opening sealing strips aside.







7. Position the LH and RH rear quarter panel trim panels aside.
^ Grasp trim panels at the top and gently pull outward to release the clips.







8. Remove the package tray.
1. Remove the pin-type retainers.
2. Remove the package tray.







9. Disconnect the LH and RH rear defroster grid wiring harness.
^ Release the harness retainers.


NOTE: RH rear defroster grid wiring harness shown, LH similar.







10. Remove the isolator module.
1. Disconnect the electrical connector.
2. Disconnect the antenna lead-in cables.
3. Remove the bolts.
4. Remove the isolator module.


INSTALLATION







1. To install, reverse the removal procedure.