Cowl Moulding / Trim: Service and Repair

COWL VENT SCREEN

Removal

NOTE: To remove the left side cowl vent screen, the right cowl vent screen must be removed first. Follow the entire cowl vent screen procedure.

Right Side Only







1. NOTE: The fasteners are reuseable.

Remove the right side of the cowl vent screen.
1 Remove the two-part pin-type retainers and separate the Velcro(R) attachment of the rubber hinge cover to the rear outboard corner of the cowl vent screen.
2 Pull up on the cowl vent screen to release the lower clips.

Entire Cowl Vent Screen







2. Remove the two wiper pivot arms.
1 Remove the two pivot arm nut covers.
2 Remove the two nuts.
3 Remove the two wiper pivot arms.







3. NOTE: Remove the right side first when removing the entire cowl vent screen.

Removeing the cowl vent screen.
1 Remove the two-part pin-type retainers and separate the Velcro(R) attachment of the rubber hinge cover to the rear outboard corner of the cowl vent screen.
2 Lift up on the cowl vent screen to release the clips.

Installation

NOTE: When installing the entire cowl vent screen, install the left side first. Follow the entire cowl vent screen procedure.

Right Side Only







1. Install the right side of the cowl vent screen.
1 Position the cowl vent screen and the Velcro(R) attachment of the rubber hinge cover.
2 Install the two-part pin-type retainers.

Entire Cowl Vent Screen







2. NOTE: Use the lower rearward clips as locators prior to installation, working from the center of the vehicle outward.

Install the cowl vent screen.
1 Position the windshield moulding flap over the left side cowl vent screen and attach the rubber hinge cover to the cowl screen.
2 Install the cowl vent screens and install the two-part pin-type retainers.

3. Cycle the windshield wiper motor to park the windshield wiper pivot arm shafts.







4. Install the windshield wiper and pivot arms onto the pivot shaft and align the blade to the heated wiper park/windshield wire lines on the windshield glass within the specification.







5. Tighten the windshield wiper pivot arm nuts.
- Install the two pivot arm nut covers.