With Rain-Sensitive Wipers

Installer, Rear View Mirror:

SPECIAL TOOL(S)

REMOVAL

CAUTION: The interior rear view mirror is a breakaway design. Excessive force in any direction will cause damage to the interior rear view mirror.







1. Remove the rain sensor module cover.

NOTE: To avoid damage to the rain sensor module cover, push up on the cover while rotating the top of the cover toward the rear of the vehicle.







2. Remove the rain sensor module.
1 Pull the latch on the connector away from the harness and disconnect the electrical connector.
2 Release the rain sensor module retaining slides.

NOTE: When removing the rain sensor module, it is necessary to apply inward pressure on the module prior to releasing the rain sensor module retaining slides.

3 Remove the rain sensor module.







3. Disconnect the electrical connector.







4. Insert a small, flathead screwdriver into the mirror base and remove the rear view mirror.

INSTALLATION







1. Install the interior rear view mirror.
1 Slide the interior rear view mirror onto the bracket.
2. Using the special tool, connect the rear view mirror to the windshield bracket.







2. Connect the electrical connector.







3. Install the rain sensor module.
^ Connect the electrical connector.

NOTE:
^ Prior to installing the rain sensor module, the windshield glass area between the rain sensor module brackets must be cleaned.
^ When installing the rain sensor module, it is necessary to apply inward pressure on the module prior to locking the rain sensor module retaining slides in place.







4. Install the rain sensor module cover.