Timing Adjustment
1. Remove the roof opening panel assembly. For additional information, refer to Panel-Roof Opening Assembly.
2. Remove the roof opening glass assembly.
1 Swing the left and right sight shields rearward.
2 Remove the screws on each side.
3 From the exterior of the vehicle, lift the roof opening glass assembly from the vehicle.
3. Disconnect the connectors.
4. Remove screws and the roof opening panel motor assembly.
5. Remove the screw and the roof opening panel control module.
6. Align the holes in the mechanism on each side.
NOTE: It may be necessary to slightly separate the rail assembly to visually see the two alignment holes.
7. Make sure the flush locating pin is centered in the slot on each side.
8. Install an alignment pin in the alignment hole in each side of the mechanism.
^ The alignment pin should be approximately 2.83 mm (0.11 in) in diameter
NOTE:
^ The alignment pins must remain in place until the roof opening panel control module is installed.
^ A number 33 drill bit may be used as an alignment pin.
9. Position the roof opening panel motor assembly on the roof opening panel control module.
10. Install the screws approximately two to three turns.
CAUTION: Do not snug or overtighten the roof opening panel mounting screws. Damage to the roof opening panel control module may result.
11. Remove the harness from the roof opening panel assembly.
12. Position the headlining panel against the right rear quarter panel.
^ The rear of the headliner should be towards the right rear door opening and the cloth side towards the vehicle.
13. Connect the headlining panel body harness connector at the right rear C-pillar.
14. Connect the roof opening panel harness between the module motor assembly and the roof opening panel switch.
15. Turn the ignition switch to RUN.
NOTE: Make sure the battery is fully charged.
16. Firmly hold the roof opening panel control module and roof opening panel motor together.
17. Operate the roof opening panel switch rearward (OPEN position) until the motor stops.
18. Operate the roof opening panel switch forward (CLOSE position) until the motor stops.
19. Disconnect the front body harness connector.
20. Remove the screws.
NOTE: Make sure the roof opening panel control module gear position is not altered.
21. Make sure the alignment hole is visible in the view hole.
22. Install the roof opening panel control module on the cable sleeves.
^ Make sure the shoulder of each cable sleeve is correctly seated in the roof opening panel control module.
NOTE: Make sure the roof opening panel control module gear position is not altered.
23. Make sure the roof opening panel control module is seated flush to the bracket and install the screw.
24. Position the roof opening panel motor assembly and install the screws.
NOTE: Make sure the roof opening panel motor is correctly aligned and inserted into the control module. The roof opening panel motor should be sitting flush with the frame before installing the bolts.
25. Connect the connectors.
26. Install the roof opening panel harness tie down and Clip into place.
27. Remove the alignment pins from each side.
28. Install the roof opening glass assembly.
1 Install the roof opening glass assembly in place aligning screw holes.
2 Install the screws on each side.
3 Swing the left and right sight shields forward and snap into place.
NOTE: Make sure to carefully align the sight shield to the snap retainer prior positioning into place.
29. Position the roof opening panel assembly near the headliner and connect the roof opening panel harness to the headliner harness.
30. Operate the roof opening panel to the full open and full close position. Make sure both sides activate at the same time and the roof opening panel operates smoothly without jerking or binding. Make sure both sides reach flush at the same time.
NOTE: Make sure the battery is fully charged.
31. Install the roof opening panel assembly. For additional information, refer to Panel-Roof Opening Assembly.
32. Adjust the roof opening glass height. For additional information, refer to Height Adjustment.