Blower Motor: Service and Repair

REMOVAL
1. Disconnect the battery ground cable. Refer to Battery.
2. Remove the passenger side floor duct.







3. Remove the screws and remove the cover.







4. Disconnect the connector and remove the blower motor.







5. Remove the wheel from the blower motor.
1 Remove the push clip.
2 Remove the wheel from the blower motor.

CAUTION: Prior to removing a wheel that is to be reused, clean any corrosion from the blower motor shaft to prevent damage to the wheel mounting diameter.

INSTALLATION
1. To install, reverse the removal procedure.

NOTE: Make sure to install the blower motor cover. It is necessary for correct cooling.