Receiver Drier, Manifold and Tube Assembly

REMOVAL
1. Perform the Refrigerant Discharging and Recovery Procedure.
2. Raise and support the vehicle. For additional information, Refer to Maintenance/Service And Repair.







3. Disconnect the peanut fitting.







4. Remove the screws and remove the air deflector.







5. Remove the air deflector.
1 Remove the push-pin retainers.
2 Remove the side-clip retainers.







6. Disconnect the peanut fitting.
7. Lower the vehicle.
8. Remove the air cleaner outlet tube. For additional information, refer to Fuel Delivery and Air Induction.







9. Remove the nut.







10. Remove the receiver drier mounting bracket clamp bolt. Move the receiver drier away from the fan shroud and remove the receiver drier.
11. Remove the receiver drier manifold assembly.

INSTALLATION
1. To install, reverse the removal procedure.
- Lubricate the O-ring seal with PAG Refrigerant Compressor Oil YN-12-C, F7AZ-19589-DA or equivalent. meeting Ford specification WSH-M1C231-B.