Driver Door Module (DDM)

REMOVAL
1. Disconnect the battery ground cable. Refer to Battery.

CAUTION:
^ Prior to removal of the module, it is necessary to upload module configuration information to the appropriate diagnostic equipment. This information needs to be downloaded into the new module once installed. For additional information, refer to Module Communications Network (Information Bus).
^ Electronic modules are sensitive to electrical charges. If exposed to these charges, damages may result.


2. Remove the driver door trim panel.






3. Remove the driver door module.
1 Disconnect the electrical connectors.
2 Remove the three bolts.
3 Remove the DDM.


INSTALLATION
1. To install, reverse the removal procedure.