Operation CHARM: Car repair manuals for everyone.

Seat Regulator Control Switch


REMOVAL

WARNING: TO AVOID ACCIDENTAL DEPLOYMENT AND POSSIBLE PERSONAL INJURY, THE BACKUP POWER SUPPLY MUST BE DEPLETED BEFORE REPAIRING OR REPLACING ANY FRONT OR SIDE AIR BAG SUPPLEMENTAL RESTRAINT SYSTEM (SRS) COMPONENTS AND BEFORE SERVICING, REPLACING, ADJUSTING OR STRIKING COMPONENTS NEAR THE FRONT OR SIDE AIR BAG SENSORS, SUCH AS DOORS, INSTRUMENT PANEL, CONSOLE, DOOR LATCHES, STRIKERS, SEATS AND HOOD LATCHES.

THE SIDE AIR BAG SENSORS ARE LOCATED AT OR NEAR THE BASE OF THE B-PILLAR.

TO DEPLETE THE BACKUP POWER SUPPLY ENERGY, DISCONNECT THE BATTERY GROUND CABLE AND WAIT AT LEAST ONE MINUTE
.

NOTE: Move the seat fully forward and make sure the seat is in the full upright position.

1. Disconnect the battery ground cable and wait at least one minute. For additional information, refer to Battery.







2. Remove the front safety belt cover by placing fingers behind the cover and pushing outward.

CAUTION: Do not use a screwdriver to remove the safety belt cover.







3. Remove the side trim panel screw.







4. Remove the side trim panel screw.







5. Remove the seat control knobs.







6. Position the seat regulator control switch plate aside.







7. Remove the screw and set aside the front cushion side shield.







8. Remove the seat regulator control switch.
1. Remove the screws.
2. Disconnect the electrical connector.

INSTALLATION
1. To install, reverse the removal procedure.