Operation CHARM: Car repair manuals for everyone.

Refrigerant System Filtering After A/C Component Replacement

Set, A/C Fittings:






SPECIAL SERVICE TOOL(S)

1. Install the new A/C compressor.
2. Install the new suction accumulator/drier.
3. Install the new A/C evaporator core orifice.







4. Orient the filter inlet toward the A/C condenser core.







5. Temporarily install the pancake filter between the A/C condenser core and the condenser to evaporator tube.

NOTE: The pancake filter is not permanently installed and will be removed at the end of this procedure.

1 Use flexible refrigerant hose of 17,238 kPa (2,500 psi) burst rating.
2 Make the connections using the R12/R134a Air Conditioning Test Fitting Set.
6. Correctly oil match the system. For additional information, refer to Refrigerant Oil Addtion.
7. Perform the Evacuation and Charging Procedure. Evacuation and Charging Procedure
8. Check all refrigerant system hoses, lines and the position of the newly installed filters to be sure they do not interfere with other engine compartment components. If necessary, use tie straps to make adjustments.
9. Provide adequate airflow to the front of the vehicle (with a fan, if necessary). Select MAX A/C operation and set the blower motor speed to maximum. Start the engine and let it idle briefly. Make sure the A/C system is operating correctly.
10. Gradually bring the engine up to 1,200 rpm by running it at lower rpms for short periods (first at 800 rpm, then at 1,000 rpm). Set the engine at 1,200 rpm and run it for one hour with the A/C system operating.
11. Stop the engine.
12. Perform the Refrigerant Discharging and Recovery Procedure.
13. Remove the fittings, flexible hoses and pancake filter from between the A/C condenser core and the condenser to evaporator tube.
14. Discard the pancake filter. It can be used one time only.
15. Reconnect the condenser to evaporator tube to the A/C condenser core.
16. Perform the Evacuation and Charging Procedure. Evacuation and Charging Procedure