Lighting Control Module (LCM)

REMOVAL
1. Disconnect the battery ground cable.

CAUTION:
^ Prior to removal of module, it is necessary to upload module configuration information to a scan tool. This information needs to be downloaded into the new module once installed. For additional information; refer to Module Communications Network (Information Bus).
^ Electronic modules are sensitive to electrical charges. If exposed to these charges, damage may result.







2. Remove the LH instrument panel lower insulator.
1 Remove the pin-type retainers.
2 Disconnect the courtesy lamp.
3 Remove the LH instrument panel insulator.







3. Position the LCM aside.
1 Remove the screws.
2 Release the locking tab.
3 Position the LCM aside.







4. Removal LCM
1 Disconnect the electrical Connectors.
2 Remove the LCM

INSTALLATION
1. To install, reverse the removal procedure.


CAUTION: Once the new module is installed, it is necessary to download the module configuration information from the scan tool into the new module. For additional information; refer to Module Communications Network (Information Bus).

NOTE: When the battery is disconnected and reconnected, some abnormal drive symptoms may occur while the vehicle relearns it adaptive strategy. The vehicle may need to be drive 16 km (10 miles) or more to relearn the strategy.