Keyless Entry Transmitter: Testing and Inspection

REMOTE TRANSMITTER PROGRAMMING

NOTE: All keyless entry remote transmitters must be programmed at the same time.

1. Turn the ignition switch from OFF to RUN 8 times within 10 seconds, ending in RUN. If the module has successfully entered program mode, it will lock and then unlock all doors.
2. Within 20 seconds, press any button on a keyless entry remote transmitter, and the doors will lock and then unlock to confirm that each keyless entry remote transmitter has been programmed. Repeat this step for each transmitter.
3. If the door locks do not respond for any keyless entry remote transmitter, wait several seconds and press the button again. If the door locks still fail to respond, refer to Power Locks.
4. Turn the ignition switch to the OFF position, or wait up to 20 seconds after Step 2, to exit program mode. If a keyless entry remote transmitter has been programmed (or reprogrammed), the doors will lock and unlock one last time to confirm.