Oil Pump: Service and Repair
Oil Pan, Oil Pump, Oil Pump Screen and Pickup Tube1. With the vehicle in NEUTRAL, position it on a hoist.
2. Drain the engine oil.
3. Remove the components in the order indicated in the illustration and table. To remove individual components, only carry flout the listed steps.
Part 2 Of 2:
4. To install, reverse the removal procedure.
Item 1: Oil Pan Bolts Removal Note
1. NOTE: LH is shown, RH is similar.
Remove the bolts.
2. NOTE: LH is shown, RH is similar.
Remove the bolts and the lateral support bar.
Items 4 and 5: Oil Pump Screen and Pickup Tube Removal Note
1. CAUTION: Only use hand tools to remove the oil pump screen and pickup tube.
Remove the bolts and the oil pump screen and pickup tube.
^ Inspect the O-ring seal and install a new one if necessary.
Items 6-8: Oil Pump Removal Note
1. Remove the timing drive components.
2. Remove the bolts and the oil pump.
^ Discard the gasket.
3. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean the sealing surfaces. These tools cause scratches and gouges, which make leaks paths. Use a plastic scraping tool to remove all traces of sealant.
Clean the sealing surfaces.
Items 6-8: Oil Pump Installation Note
1. Install a new gasket.
2. Install the oil pump and tighten the bolts in two stages.
^ Stage 1: Tighten to 6 Nm (53 inch lbs.).
^ Stage 2: Tighten an additional 90 degrees.
3. Install the timing drive components.
Items 4 and 5: Oil Pump Screen and Pickup Tube Installation Note
1. NOTE: Apply clean engine oil to the O-ring seal prior to installing.
Install the oil pump screen and pickup tube.
Items 1-3: Oil Pan Installation Note
1. NOTE: Make sure all gasket sealing surfaces are clean and dry.
Install a new oil pan gasket and the oil pan. Tighten the bolts in the sequence shown in two stages.
^ Stage 1: Tighten to 5 Nm (44 inch lbs.).
^ Stage 2: Tighten to 12 Nm (9 ft. lbs.).
2. NOTE: LH is shown, RH is similar.
Position the lateral support bars and install the bolts.
3. NOTE: LH is shown, RH is similar.
Install the bolts.
4. Fill the crankcase with clean engine oil.