Sensor, Front
Front Wheel Speed Sensor and Sensor Ring1. With the vehicle in NEUTRAL, position on a hoist.
Part 1 Of 2:
Part 2 Of 2:
2. Remove the components in the order indicated in the table.
3. To install, reverse the removal procedure.
Item 4: Wheel Speed Sensor Harness Removal Note
1. Position the inner splash shield aside.
1. Remove the pin-type retainers.
2. Position the inner splash shield aside.
2. Disconnect the wheel speed sensor electrical connector.
3. Unclip the wheel speed sensor harness.
Item 6: Wheel Speed Sensor Ring Removal Note
1. The wheel speed sensor ring is integral to the wheel hub assembly and is not serviced separately.
Item 2: Wheel Speed Sensor Installation Note
1. Apply a 2.5 mm (0.1 inch) bead of sealant to the outside diameter of the wheel speed sensor.
Item 1: Clip Installation Note
1. Make sure the wheel speed sensor is fully seated before installation of the new clip.