Band Apply Servo: Service and Repair

Reverse Servo Assembly

Removal and Installation

NOTE: The transmission fluid pan gasket is reusable. Clean and inspect for damage. If not damaged, the gasket should be reused.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the components in the order indicated in the illustration and table.








3. To install, reverse the removal procedure.
4. Partially fill the transmission.

Item 2: Heated Oxygen Sensor Electrical Connector Removal Note





1. Disconnect the heated oxygen sensor connector and remove the sensor wire retaining clip from the right side of the transmission pan rail.

Item 3: Heated Oxygen Sensor Electrical Connector Retainer Removal Note





1. Remove the heated oxygen sensor connector from the front of the transmission pan rail.

Item 9: Reverse Servo Screws Installation Note





1. Install the reverse servo. Tighten the screws in the sequence shown in two stages.
^ Stage 1: Tighten screws to 5 Nm (44 inch lbs.).
^ Stage 2: Tighten screws to 11 Nm (8 ft. lbs.).

Item 7: Transmission Fluid Pan Installation Note





1. Install the transmission fluid pan and gasket, and loosely install the screws.

Item 6: Transmission Fluid Pan Screws Installation Note





1. Tighten the screws in a crisscross sequence.

Item 3: Heated Oxygen Sensor Electrical Connector Retainer Installation Note





1. Install the heated oxygen sensor connector from the front of the transmission pan rail.

Item 2: Heated Oxygen Sensor Connector Installation Note





1. Connect the heated oxygen sensor connector and install the sensor wire retaining clip to the right side of the transmission pan rail.