Test K

PINPOINT TEST K: THE ONE-TOUCH UP/DOWN FEATURE IS INOPERATIVE

Test K1-K4:

Test K4 Continued:

Normal Operation

NOTE:
- Excessive bounce-back (bounce/back that occurs with no obstructions present) may indicate a non-initialized window motor.
- The front window motors must be initialized whenever: the motor is removed from the window regulator, a new motor is installed, a new window regulator is installed, a new window glass is installed, a glass top run removal and installation and when carrying out any operation in which grease or lubricants are applied to the window system. A new front window motor will be in a proportional up/down mode until initialized.
- If this procedure is only partially completed, the front window motor will remain non-initialized and only the proportional up/down functions will operate. A non-initialized window motor may allow one-touch down operation, but will NOT allow one-touch up operation.

If the front window control switch is pressed (key ON) to the second detent, one-touch operation will occur in the commanded direction when power is sent from the front window control switch to the front window motor over circuit 8-AJ42 (WH/GN) (LF) or circuit 8-AJ56 (WH/GN) (RF).

Possible Causes
- loss of B+ power (30-AJ8O {RD/OG} {LH front}, 30-AJ71 {RD/YE} {RH front}) to the smart window motor
- new smart window motor that has not been initialized
- new components that may affect the window travel
- window motor
- front window control switch