Fill

Power Steering System Filling

WARNING: Do not mix fluid types. Any mixture or any unapproved fluid could lead to seal deterioration and leaks. A leak can ultimately cause loss of fluid, which can result in a loss of power steering assist.





1. Fill the power steering reservoir to the appropriate level.
2. Remove the ignition coil fuse number F2-12 in the central junction box to disable the engine from starting.
3. Raise the front wheels off the floor.

4. CAUTION: Do not operate the starter motor for more than 10 seconds at a time. Damage to the starter motor can result.





Turn the steering wheel from stop-to-stop while cranking the engine.
5. Lower the vehicle.

6. CAUTION: Do not overfill the power steering fluid reservoir.





Fill the power steering fluid reservoir to the appropriate level.
7. Install the ignition coil fuse number F2-12 in the central junction box.

8. NOTE: If the power steering is noisy and accompanied by evidence of aerated fluid it will be necessary to purge the power steering system.

Clear the diagnostic trouble codes (DTCs).
^ Start the engine and check the system for leaks.