Ignition Coil: Service and Repair
IGNITION COIL-ON-PLUGLH Side:
RH Side:
Exploded View
Removal and Installation
RH ignition coils
1. Remove the upper intake manifold.
All ignition coils
2. Disconnect the 6 ignition coil electrical connectors.
3. Remove the 6 ignition coil bolts.
- To install, tighten to 5 Nm (44 lb-in).
4. NOTE: When removing the ignition coils, a slight twisting motion will break the seal and ease removal.
Remove the 6 ignition coils.
5. To install, reverse the removal procedure.
- Apply a light film of silicone brake caliper grease and dielectric compound to the inside of the coil boots before installation.