Audio Unit

AUDIO UNIT







Removal and Installation
1. Remove the floor console finish panel.
- Pull upward from the front of the floor console finish panel to release the retainers.

2. Remove the 4 screws and the console ash tray assembly.
- Disconnect the electrical connectors.

3. Remove the center register panel.
- Disconnect the electrical connector.

4. Remove the 4 screws and the audio unit/dual automatic temperature control (DATC) assembly.
- Disconnect the electrical connectors and the antenna cable.

5. Remove the 6 screws and the audio unit from the bracket.
6. To install, reverse the removal procedure.