Rear Seat Cushion

REAR SEAT CUSHION







Disassembly and Assembly







1. Using a suitable tool, release the mini-buckle.







2. Release the 2 levers located at the lower outboard edges of the seat cushion, lift the cushion up and pull the cushion out.







3. If equipped, disconnect the heated seat electrical connectors at both outboard sides of the seat cushion.
4. Remove the seat cushion.
5. If equipped, remove and disconnect the right heated seat module.
6. If equipped, remove and disconnect the left heated seat module.
7. Remove all the outer seat cushion trim cover hog rings.

8. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat cushion foam pad.

Separate the hook and loop fasteners.

9. Remove all the inner seat cushion trim cover hog rings.
10. Remove the seat cushion trim cover.
11. If equipped, disconnect and remove the right cushion heater element as needed.
12. If equipped, disconnect and remove the left cushion heater element as needed.
13. To assemble, reverse the disassembly procedure.