Control Assembly: Service and Repair

CLIMATE CONTROL ASSEMBLY







Removal and Installation

NOTE: If installing a new climate control assembly (dual-zone EATC module), the new module must be configured for the vehicle.

1. Remove the center instrument panel register.
2. Remove the lower center finish panel.
3. Remove the 2 switch panel screws.
4. Remove the switch panel.
5. Disconnect the power point electrical connector.
6. Remove the 4 audio unit screws.
7. Disconnect the climate control assembly electrical connector.
8. Disconnect the antenna cable from the audio unit.
9. Remove the 4 climate control assembly screws.
10. Remove the climate control assembly.
11. To install, reverse the removal procedure.