Fuel Transfer Pump

FUEL TRANSFER PUMP

Fuel Sender Wrench:

Special tool(s)







Removal
1. Drain the fuel tank.
2. Partially raise the fuel transfer pump and disconnect the internal fuel crossover tube quick release fittings and remove the fuel transfer pump.
- Remove and discard the fuel transfer pump gasket.

Installation

1. NOTE: Make sure that the fuel crossover tubes are routed correctly.

Partially raise the fuel transfer pump and connect the internal fuel crossover tube quick disconnect fittings.







2. Using the special tool, install the fuel transfer pump and lock ring.
- Install a new fuel transfer pump gasket.
- Tighten to 80 Nm (59 lb-ft).







3. Using the special tool, install the fuel pump module and lock ring.
- Install a new fuel pump module gasket.
- Tighten to 80 Nm (59 lb-ft).







4. Connect the fuel pump module and fuel transfer pump electrical connectors.







5. Install the fuel pump module and fuel transfer pump access covers.
6. Install the rear seat bottom and any insulation padding covering the access covers.
7. Tighten the 2 fuel tank support strap bolts.
- Tighten to 35 Nm (26 lb-ft).

8. Connect the battery ground cable.