Ignition Switch Lock Cylinder: Service and Repair

IGNITION LOCK CYLINDER







Removal and Installation

NOTE:
- When any new lock cylinder is installed, the luggage compartment lid lock cylinder, the driver door lock cylinder, and ignition lock cylinder should be installed as a set. This eliminates carrying an extra key that fits only 1 lock. If a new key is used, the new key code number is stamped on a metal tag attached to the key.
- Individual lock cylinders are repaired by discarding the inoperative cylinder and building a new lock cylinder using the appropriate lock repair package. The lock repair package includes a detailed instruction sheet to build the new lock cylinder to the current key code of the vehicle.

1. Disconnect the battery and wait at least 1 minute to allow for depletion of the restraint system back up power supply.
2. Remove the steering column cover.
3. Remove the inner instrument panel finish panel.
4. Turn the ignition switch to the RUN position.
5. Using a small flat-blade screwdriver, press and hold the ignition lock cylinder release button.
6. Remove the ignition lock cylinder.
7. To install, reverse the removal procedure.
- Lubricate the ignition lock cylinder before installing it.