Transmitter

REMOTE TRANSMITTER PROGRAMMING

NOTE: Programming (or reprogramming) of the remote transmitters can be accomplished using a diagnostic tool or by carrying out the following steps:

1. Cycle the key from OFF to RUN 8 times within 10 seconds with the 8th time ending in RUN. The locks will then lock and unlock, confirming that the program mode has been entered.

2. NOTE: When the first remote transmitter is programmed, all other remote transmitters are erased. So all remote transmitters should be programmed when one remote transmitter is programmed.

Press any button on the transmitter to be programmed.

3. If additional remote transmitters are to be programmed, repeat Step 2 within 7.5 seconds.
4. To exit program mode, turn the key to START or wait 7.5 seconds.