Front

Stabilizer Bar

Removal and Installation

1. WARNING: The electrical power to the air suspension system must be turned off prior to hoisting, jacking or towing an air suspension vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.





CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. A new part with the same part number must be installed if installation becomes necessary. If substitution is necessary, the part must be of the same finish and property class. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

Turn the air suspension service switch off.
2. Raise the vehicle on a hoist.





3. NOTE: Use the hex holding feature to prevent the stud from turning while removing the nut.

Remove the two nuts and the stabilizer bar links.
^ Discard the nuts.





4. Remove the four nuts, the two brackets and the stabilizer bar.
^ Discard the nuts.

5. To install, reverse the removal procedure.