Rear

Stabilizer Bar and Link

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. New fasteners must be installed with the same part number or an equivalent part if installation is necessary. Do not use a replacement part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts. Orientation of the fasteners is also important on all rear suspension arms. Make sure the fasteners are installed in the same direction as they were in when removed.





1. WARNING: The electrical power to the air suspension system must be turned off prior to hoisting, jacking or towing an air suspension vehicle. Failure to do so can result in unexpected inflation or deflation of the air springs, which can result in shifting of the vehicle during these operations.

Turn the air suspension service switch off
2. Raise and support the vehicle.





3. Remove the two nuts, washers and bushings.
^ Discard the nuts.





4. Remove the two nuts, the washers and bushings, and the stabilizer bar links.
^ Discard the nuts.





5. Remove both bolts, brackets and the stabilizer bar.
6. To install, reverse the removal procedure.