Console: Service and Repair

FLOOR CONSOLE







Removal and Installation
1. Position the seats as needed to remove the console.
2. Disconnect the battery.
3. Remove the floor console storage bin.
1 Remove the 3 screws and the armrest.
2 Remove the floor console storage bin screw.
3 Remove the pin-type retainer.
- Disconnect the electrical connectors.

4. Remove the floor console front finish panel.
- Pull upward from the front of the trim panel to release the retainers.
- Disconnect the electrical connectors.

5. Remove the floor console center finish panel.
6. If necessary, remove the 2 screws and the floor console cup holder.
7. Remove the 2 floor console front screws.
8. Remove the 3 floor console rear screws.
- To install, tighten to 4 Nm (35 lb-in).

9. NOTE: Lift the console from the rear and slide it rearward to release the rear seat heater ducts from the instrument panel.

Remove the nut and the floor console.
- Disconnect the electrical connector.
- To install, tighten to 8 Nm (71 lb-in ).

10. To install, reverse the removal procedure.